cfr_sections: 14:14:1.0.1.3.13.3.87.53
Data license: Public Domain (U.S. Government data) · Data source: Federal Register API & Regulations.gov API
This data as json
| section_id | title_number | title_name | chapter | subchapter | part_number | part_name | subpart | subpart_name | section_number | section_heading | agency | authority | source_citation | amendment_citations | full_text |
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| 14:14:1.0.1.3.13.3.87.53 | 14 | Aeronautics and Space | I | C | 25 | PART 25—AIRWORTHINESS STANDARDS: TRANSPORT CATEGORY AIRPLANES | C | Subpart C—Structure | 25.509 | § 25.509 Towing loads. | FAA | 49 U.S.C. 106(f), 106(g), 40113, 44701, 44702 and 44704; Pub. L. 115-254, 132 Stat 3281 (49 U.S.C. 44903 note). | Docket No. 5066, 29 FR 18291, Dec. 24, 1964, unless otherwise noted. | [Doc. No. 5066, 29 FR 18291, Dec. 24, 1964, as amended by Amdt. 25-23, 35 FR 5673, Apr. 8, 1970] | (a) The towing loads specified in paragraph (d) of this section must be considered separately. These loads must be applied at the towing fittings and must act parallel to the ground. In addition— (1) A vertical load factor equal to 1.0 must be considered acting at the center of gravity; (2) The shock struts and tires must be in their static positions; and (3) With W T as the design ramp weight, the towing load, F TOW, is— (i) 0.3 W T for W T less than 30,000 pounds; (ii) ( 6W T + 450,000)/70 for W T between 30,000 and 100,000 pounds; and (iii) 0.15 W T for W T over 100,000 pounds. (b) For towing points not on the landing gear but near the plane of symmetry of the airplane, the drag and side tow load components specified for the auxiliary gear apply. For towing points located outboard of the main gear, the drag and side tow load components specified for the main gear apply. Where the specified angle of swivel cannot be reached, the maximum obtainable angle must be used. (c) The towing loads specified in paragraph (d) of this section must be reacted as follows: (1) The side component of the towing load at the main gear must be reacted by a side force at the static ground line of the wheel to which the load is applied. (2) The towing loads at the auxiliary gear and the drag components of the towing loads at the main gear must be reacted as follows: (i) A reaction with a maximum value equal to the vertical reaction must be applied at the axle of the wheel to which the load is applied. Enough airplane inertia to achieve equilibrium must be applied. (ii) The loads must be reacted by airplane inertia. (d) The prescribed towing loads are as follows: |